When working with the mesh module there is a known issue that can sometimes may occur depending on the users workflow. If This being when a user runs the initial mesh studies, and then that user goes back to their sites and makes changes to either the antenna pattern files or , edits the transmit or /receive parameters, or just in general make changes. That user should then go into the menu . Or the user makes changes to the propagation model dialogue or to their terrain/clutter databases. After making these changes the user may notice that their new mesh study results do not seem different. The user should clear all caches within the MegaMesh menu in order to see their changes take place. The user might also want to navigate to Studies>Study Preferences and press the “reset all working files button” . Then they should go back into MegaMesh and they should also if the user is running any area studies along with their Mesh studies.
...
Under MegaMesh you will want to go and clear the cache files located under the Setup Mesh Studies menu. You will want to clear the router cache for for single router calculations, this is the more important cache to clear. The first option to clear router cache for initial sorting will clear the caches used for setup, repeater chaining, auto placement, and sampling. There is also an option within the setup and sort menu . They should where you can also clear the propagation cache files.
...
And lastly, It could be a good idea to re-run the entire mesh study process after clearing the cache files in order to see those changes made to the site.The reason this issue occurs is because within MegaMesh, after setup process if you have made changes to a Transmitter, so that the connecting Transmitters are much different. With meshing the exact details of what mesh to router are unimportant as the router will usually hit the closest stuff. From within the Run Mesh Studies dialogue you can go into the algorithm setup dialogue and just press save. This will clear the cache files and when you run initialize routers the cache files will rebuild.
This issue occurs because during the process of running your mesh studies, the program builds a cache file files for those studies. These cache files get re-used when running the mesh studies again to help speed up calculation times. If you make changes to your sites, which are outside of the MegaMesh menu, those site changes dont do not get taken into effect, because as a result of the cache files that were built from the previous mesh study. You must
| Note |
|---|
If you clear the cache files |
...
, they will rebuild as needed during the calculations. |
If a user also makes propagation model changes or edits of any kind are made, they you should go through the same process of clearing their the caches files and running a fresh mesh study in order to see those changes taken into effect during the effectcalculations/studies. The mesh module works by reading cache files from previous runs of the study in order to save time. If the user makes changes are made to the prop propagation model or to their a site, they you will need to clear and rebuild their the cache files to before you see the accurate results reflected from their changes.your changes.
If you have any questions about this topic or find that this does not help resolve your issue, please submit a support ticket here: https://edxwireless.atlassian.net/servicedesk/customer/portal/2